Level The Washer - GE Profile WPGT9150 Manuel D'utilisation Et D'installation

SET REAR LEGS
6
Tilt the washer forward (pivot on front legs)
about 4 to 6 inches and gently lower the rear legs
back onto the floor. This action will set rear leg
adjustments to correspond to front settings.

LEVEL THE WASHER

7
Move the washer into final position.
• To check if the washer is level side to side,
open the lid and place a level at the back of
the opening above the dispenser drawer.
• To check if the washer is level front to back,
place a level at the side of the washer on the
edge where the cabinet side meets the top cover.
Lower
If the washer is not level, adjust the front leveling
legs. Turn clockwise to raise, counterclockwise to
lower.
Installation Instructions
Raise
15