Start Of Dishwasher; Troubleshooting Tips - CONFORAMA SABA LVS14C44MI18W Mode D'emploi

Extension Hose
If you need a drain hose extension, make sure to use a similar
drain hose. It must be no longer than 4 metres; otherwise the
cleaning effect of the dishwasher could be reduced.
Syphon Connection
The waste connection must be at a height less than 1000 mm
(maximum) from the bottom of the dish. The water drain hose
should be fixed .

Start of Dishwasher

GB
The following things should be checked before starting the
dishwasher.
1. The dishwasher is level and fixed properly
2. The inlet valve is open
3. There is a leakage at the connections of the conducts
4. The wires are tightly connected
5. The power is switched on
6. The inlet and drain hoses are knotted
7. All packing materials and printings should be taken out from
the dishwasher
Attention:
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
109

9. Troubleshooting Tips

Before Calling for Service
Review the charts on the following pages may save you from
calling for service.
Problem Possible Causes What to Do
Fuse blown,
or thecircuit
breaker acted
Power supply is
Dishwasher
not turned on
doesn't start
Water pressure
is low
Technical
Door of dish
problems
washer not
properly closed.
Kink in drain
hose
water not Filter clogged
pumped orm
dishwasher
Kitchen sink
clogged
Replace fuse or reset circuit breaker. Remove
any other appliances sharing the same circuit
with the dishwasher
Make sure the dishwasher is turned on and
the door is closed securely.
Make sure the power cord is properly plugged
into the wall socket.
Check that the water supply is connected
properly and the water is turned on.
Make sure to close the door properly and
latch it.
Check drain hose.
Check coarse the filter (see section titled
"Cleaning The Filter")
Check the kitchen sink to make sure it is
draining well. If the problem is the kitchen sink
not draining, you may need a plumber rather
than a serviceman for dishwashers.
GB
110