Cleaning The Door - CONFORAMA SABA LVS14C44MI18W Mode D'emploi

Cleaning the Door

WARNING!
GB
• Never use a spray cleaner to clean the door panel as it may
damage the door lock and electrical components.
• Abrasive agents or some paper towels should not be used
because of the risk of scratching or leaving spots on the
stainless steel surface.
Protect Against Freezing
please take frost protection measures on the dishwasher in
winter. Every time after washing cycles, please operate as
follows:
1. Cut off the electrical power to the dishwasher.
2. Turn off the water supply and disconnect the water inlet
pipe from the water valve.
3. Drain the water from the inlet pipe and water valve.
(Use a pan to gather the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge
to soak up water in the sump.
103
To clean the edge around the door,
you should use only a soft warm,
damp cloth.
To avoid penetration of water into the
door lock and electrical components,
do not use a spray cleaner of any kind.
NOTE:
If your dishwasher cannot work because of the ice, please contact
professional service persons.
Cleaning the Spray Arms
It is necessary to clean the spray arms regularly for hard water
chemicals will clog the spray arm jets and bearings.
To remove the upper spray arm, hold the nut, rotate the arm
clockwise to remove it.
To remove the lower spray arm, pull out the spray arm upward.
Wash the arms in soapy and warm water and use a soft brush to
clean the jets. Replace them after rinsing them thoroughly.
Open
How To Keep Your Dishwasher in Shape
• After Every Wash
After every wash, turn off the water sup ply to the appliance and
leave the door slightly open so that moisture and odours are not
trapped inside.
GB
104