CONFORAMA SABA LVS14C44MI18W Mode D'emploi page 41

1. Switch on the appliance;
2. Press the button for more than 5 seconds to start
Start/Pause
the water softener set model within 60seconds after the
appliance was switched on (The Salt and Rinse aid warning
lights will be on periodically when it get in the set model);
3. Press the button to select the proper set according to
Start/Pause
your local environment, the sets will change in the following
sequence: H1->H2->H3->H4->H5->H6;
4. Press the Power button to end the set up model.
GB
WATER HARDNESS
°dH °fH °Clarke mmol/l
0~5 0~9 0~6
6-11 10-20 7-14
12-17 21-30 15-21 2.1-3.0
18-22 31-40 22-28 3.1-4.0
23-34 41-60 29-42 4.1-6.0
35-55 61-98 43-69 6.1-9.8
Note: 1
1°dH=1.25°Clarke=1.78°fH=0.178mmol/l
°dH: German degree
°fH: French degree
°Clark: British degree
Note: 2
The manufactory setting: H3 (EN 50242)
Contact your local water board for information on the hardness of
your water supply.
77
Salt
Selector
consumption
Position
(gram/cycle)
0~0.94 H1 0
1.0-2.0 H2 9
H3 12
H4 20
H5 30
H6 60
NOTE: If your model does not have any water softener, you
may skip this section.
WATER SOFTENER
The hardness of the water varies from place to place. If hard water
is used in the dishwasher, deposits will form on the dishes and
utensils.
The appliance is equipped with a special softener that uses a salt
container specifically designed to eliminate lime and minerals
from the water.
B. Loading the Salt Into the Softener
Always use the salt intended for use with dishwasher.
The salt container is located beneath the lower basket and should
be filled as explained in the following:
Attention!
• Only use salt specifically designed for the use in dishwashers!
Every other type of salt not specifically designed for the use
in a dishwasher, especially table salt, will damage the water
softener. In case of damages caused by the use of unsuitable
salt the manufacturer does not give any warranty nor is liable
for any damages caused.
• Only fill with salt just before starting one of the complete
washing programs. This will prevent any grains of salt or salty
water, which may have been spilled,remaining on the bottom
of the machine for any period of time, which may cause
corrosion.
GB
78