CONFORAMA SABA LVS14C44MI18W Mode D'emploi page 51

Change the Program...
Premise:
1. A cycle that is underway can only be modified if it has only
been running for a short time. Otherwise, the detergent
may have already been released, and the appliance may
have already drained the wash water. If this is the case, the
detergent dispenser must be refilled (see the section entitled
"Loading the Detergent" ).
2.
P ress the Start/Pause button, the machine will be in standby
GB state, press the program button more than 3s then you can
change the program to the desired cycle setting (see the
section entitled "Starting a wash cycle. . ." ).
NOTE:
If you open the door during a wash cycle, the machine will pause.
The program light will stop blinking and the buzzer will mooing
every minute unless you close the door. After you close the door,
the machine will keep on working.
IF Your model has broken remember function, the machine will
go on to finish the selected program after the power cut.
97
Forgot to Add a Dish?
A forgotten dish can be added any time before the detergent
cup opens.
1. Press the Start/Pause Button to stop the washing.
2. Open the door a little.
3. After the spray arms stop working, you canopen the door
completely.
4. Add forgotten dishes.
5. Close the door
6. Press the Start/Pause Button, the dishwasher will run after
10 seconds.
At the end of the Wash Cycle
When the working cycle has finished, the buzzer of the
dishwasher will sound for 8 seconds, then stop. Turn off the
appliance using the Power switch button, shut off the water
supply and open the door of the dishwasher. Wait for a few
minutes before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more
susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
1. Switch off the dishwasher by pressing the Power button.
2. Turn off the water tap!
GB
98