Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SPECIFIC WARNINGS & SAFETY RULES
ADDITIONAL SAFETY WARNINGS
Always assume that the tool contains fasteners.
Careless handling of the tool can result in unexpected firing
of fasteners and personal injury.
Do not point the tool towards yourself or anyone
nearby. Unexpected triggering will discharge the fastener
and can cause an injury.
Do not actuate the tool unless the tool is placed
firmly against the workpiece. If the tool is not in
contact with the workpiece, the fastener may be deflected
away from your target.
Ensure power switch is in off position and keep
tool disconnected from the power source when the
fastener jams in the tool. While removing a jammed
fastener, the tool may be accidentally activated if it is
charged and in the on position or plugged in and connected
to its charger.
Use caution while removing a jammed fastener.
Point the tool away from self or others. The mechanism may
be under compression and the fastener may be forcefully
discharged while attempting to free a jammed condition.
Do not use this tool for fastening electrical cables.
It is not designed for electric cable installation and may
damage the insulation of electric cables, thereby causing
electric shock or fire hazards.
SPECIFIC SAFETY RULES
1. Hold tool by insulated gripping surfaces when
performing an operation where the tool may
contact hidden wiring or its own cord. Contact
with a "live" wire will also make exposed metal parts of
6
the tool "live" and can shock the operator.
2. Know your power tool. Read operator's manual
carefully. Learn its applications and limitations, as well
as the specific potential hazards related to this tool.
Following this rule may reduce the risk of electric shock,
fire, or serious injury.
3. Always wear safety glasses with side shields.
Everyday glasses have only impact resistant lenses. They
are NOT safety glasses. Following this rule may reduce
the risk of eye injury.
4. Protect your hearing. Wear hearing protection during
extended periods of operation. Following this rule may
reduce the risk of serious personal injury.
5. Protect your lungs. Wear a face or dust mask
if the operation is dusty. Following this rule may
reduce the risk of serious personal injury.
6. Do not abuse charger cord. Never carry tool by
charger cord. Never yank cord to disconnect it from
receptacle. Keep charger cord away from heat, oil
and sharp edges, and moving parts.
7. Do not attempt to alter the tool. Your T50DCD™
has a tested cycling time. It is designed to perform
adequately at this rate. Any unauthorized alteration
and/or use could result in a hazardous condition causing
possible serious personal injury. Unauthorized parts
and/or tool modification automatically voids warranty.
8. Use only ARROW
replacement parts.
®
9. Use proper charging device. While charging,
the tool should always be supplied via a residual current
device with a rated residual current of 20 mA or less.
DEFINITION OF SYMBOLS USED ON TOOL
& FUNCTIONAL DESCRIPTION
FUNCTIONAL DESCRIPTION
Obey all safety messages that follow this
symbol to avoid possible injury or death.
V ...................... Volts
A ...................... Amperes
To avoid loss of hearing, always wear
Hz .................... Hertz
ear protection when operating the tool.
- ...................... Alternating Current
Air vents
Trigger
Staple exit
To avoid eye injury always
wear safety glasses when
operating the tool.
Battery Status Indicator
Charge port
3.6v built-in
Lithium-ion battery
On/off switch
Quick release
magazine
Contact safety.
7
Publicité
Table des Matières
