Important Idling Information; Stopping The Engine; Starting A Warm Engine - McCulloch MB2500BP Mode D'emploi

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983

6-2. IMPORTANT IDLING INFORMATION

In some cases due to operating conditions (altitude, tem-
perature etc.) your blower may need a slight adjustment
to the idle speed.
After warm up, If unit does not Idle after restarting 2
times, follow these steps to adjust idle.
1. Locate the idle adjustment screw (E) on the carbure-
tor (Fig. 6-2).
2. Using a Phillips or slotted screwdriver - turn screw 1/4
to 1/2 turn clockwise (to the right). Unit should then
idle properly.
E

6-3. STOPPING THE ENGINE

Emergency Stopping Procedure. When it is necessary
to stop blower engine immediately, DEPRESS the OFF
"STOP " switch until the engine stops completely (Fig.
6-3).
Normal Stopping Method. For normal stopping, release
trigger and allow engine to return to idle speed. Then
DEPRESS the OFF "STOP
stops completely. (Fig. 6-3)
9
6 - STARTING/STOPPING INSTRUCTIONS
6-2
" switch until the engine
6-3
www.mymowerparts.com www.mymowerparts.com
6-4. STARTING A WARM ENGINE (Engine has
been stopped for no more than 15-20 min-
utes).
1. Set throttle (see step 1 for starting a cold engine),
choke "3", pull starter rope.
2. If engine does not start, or starts and then stops
after 5 rope pulls, follow procedure "STARTING A
COLD ENGINE".