Step 3. Configuring Wireless Settings - Belkin F1UP0002 Mode D'emploi

Installation Procedure

Step 3. Configuring Wireless Settings

1.
The default wireless setting is "Auto" mode. The Print Server
will detect a connection to a wired-L AN network through
the attached Ethernet cable. If the Print Server is connected
to a wired network, it will work in that network. To enable
wireless mode, the Ethernet cable must be disconnected
after final configurations. However, the Ethernet cable needs
to stay plugged in for the required wireless configurations
in this section. For more detailed information about wireless
settings, refer to the "Wireless Configuration" section.
2.
The "Wireless Network Settings" screen of the Print Server
will automatically scan the wireless networks nearby. Select
the wireless network to which you would like to connect
and click "Next". Alternatively, you can manually enter
the wireless-network information ("Manual" mode).
The default wireless settings are as follows:
Mode:
Infrastructure
SSID:
Default
Channel:
11
19 19
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17