Troubleshooting - Belkin F1UP0002 Mode D'emploi

Troubleshooting

This product is not found even after searching
1.
by the Belkin All-In-One Print Manager.
• Check if the power adapter and the network cable
are connected to the Print Server properly.
• Check if the L AN or WL AN LED is turned on.
• Check if the IP address of the Print Server is in
the network segment as your computer.
- If you are not sure of the Print Server's IP-
address setting, check the TCP/IP setting of the
Print Server from the Server Manager.
Following are instructions on how to
2.
change the Print Server's IP address:
• A DHCP server is installed in the network.
If a DHCP server is installed, you can choose
to allow the Print Server to get an IP address
from the DHCP server automatically.
1.
Open "Server Manager" and then select "TCP/IP" setting.
2.
Select "Auto IP" and click "Save".
3.
Reboot the All-In-One Print Server.
129 129
1
2
3
4
5
6
7
8
9
10
11
12 12
13 13
14 14
15 15
16 16
17 17