Belkin F1UP0002 Mode D'emploi page 130

Troubleshooting
1
• Set up the IP address manually.
2
1.
2.
3
3.
4
Note:
Server might be beneficial in cases where the
5
DHCP server's availability is intermittent.
6
3. A user always connects the Print Server.
7
• Contact the current user and ask him or
her to disconnect the device.
8
• If the user forgets to disconnect the device, you can
inform the administrator to release the device.
9
4. I can't use the multifunction printer (MFP)
10
to scan, print, read the card reader, or fax a
file, even though I have followed installation
11
procedures as written in this User Manual.
• Check if the MFP you are using is in the Compatibility
12
12
List in on Belkin's Technical-Support website.
• Attach the MFP to the computer directly to
13
13
see if all the functions work properly.
14
14
5. My computer has a firewall installed and
the Print Server can't work normally.
15
15
• Some firewalls (for example, the "Network Access Manager"
firewall program attached with nVidia network cards) may
16
16
block the communication between the Print Server and your
17
17
Open "Server Manager" and then select "TCP/IP" setting.
Select "Static IP" and enter the IP address and subnet mask
by referring to your computer's TCP/IP settings. Click "Save".
Reboot the Print Server.
Setting up a static IP address to the Print
130