Setup And Configuration - Belkin F1UP0002 Mode D'emploi

UNIX/Linux-System Network

Setup and Configuration

To configure the Print Server for LPD printing, perform the
procedures below:
1.
Enable the Print Server's TCP/IP support.
2.
Set up the Print Server's IP address.
3.
Verify the Print Server's IP address.
4.
Configure remote LPD printing on the host.
5.
Print a test page.
In the next sections, we will describe these
five procedures step by step.
Enable the Print Server's TCP/IP Support
The Print Server's default configuration is to have TCP/IP support
enabled. You can also configure the Print Server to enable TCP/IP
support using the configuration program.
Set Up Print Server's IP Address
The Print Server must have a unique IP address in order to be
recognized by the network.
You can set up the IP address on the various UNIX /Linux systems
using any one of the following methods:
1. DHCP
(Dynamic Host Configuration Protocol)
2. BOOTP
(Bootstrap Protocol)
The Print Server will use the last two methods to obtain its IP
address automatically if its IP address is configured as "Auto"
(0.0.0.0).
121 121
1
2
3
4
5
6
7
8
9
10
11
12 12
13 13
14 14
15 15
16
16
17
17