Belkin F1UP0002 Mode D'emploi page 18

Installation Procedure
1
2
3
4
5
6
7
The Print Server will check if the manually configured IP
address in "TCP/IP Configuration" is in the same subnet
8
as the connected computer running the installation utility.
If the TCP/IP-address settings configured manually
9
are in a different IP subnet than that of the connected
computer, the user will be prompted by the alert message
shown below. Click "OK" to go back and configure the
10
correct IP-address settings for the Print Server.
11
12
13
Note:
Server at some point after the installation, you can use the
14
Server-Manager utility's TCP/IP- configuration option.
15
16
17
If you want to change the TCP/IP settings of the Print
18