Preparing Sensors And Registering Them In Controller; Registering Sunscreening Products In Controller - Velux integra active KRX 100 Guide De Démarrage Rapide

Initial set-up
Preparing sensors and registering them
in the controller
Note: items 1-5 must be completed within 10 minutes.
in case of more solar sensors, register these as described
in the section Registering new solar sensors.
1
Prepare sensors for registration:
Press the button at the bottom of the sensor with a
pointed object for at least 5 seconds until the diode
flashes.
2
Register sensors in controller KRX:
Press "Register" to register the two sensors.
3
Registration is running. this might take some minutes.
4
the display shows "Sensor registered" when the sen-
sors have been registered.
Press "Continue" to proceed.
5
the display shows that the program VELUX ACtiVE
has not been enabled.
Press "Enable" to start registration of sunscreening
products in the controller.
6
Do not press "Register" until the sunscreening products
have been prepared via a remote control (pages 17-23).
16 VELUX
auto set-uP
Prepare sensors
for registration and
press Register
within 10 minutes
Register
auto set-uP
inFoRmation
sensor
registered
Continue
inFoRmation
velux aCtive
not enabled
Menu
auto set-uP
Prepare products
for registration and
press Register
Register
ENGLISH
Registering sunscreening products in the
controller
the sunscreening products must be copied from existing
remote controls to controller KRX
Back
types of remote controls:
VELUX remote control A
if the sunscreening products are operated with VELUX
remote control A, continue with pages 18-19.
VELUX remote control B
Enable if the sunscreening products are operated with VELUX
remote control B, continue with pages 20-21.
Back
KRX
A
B
ENGLISH
VELUX 17