Initial Set-Up; Preparing Controller - Velux integra active KRX 100 Guide De Démarrage Rapide

Initial set-up

Preparing controller

1
Connect to mains supply:
Remove the back cover of the controller as shown. Click
the adaptor plug into the controller and replace the
cover. Connect the adaptor to mains supply.
Note: the controller saves the selected settings even if
the mains supply is disconnected. therefore, it is advis-
able not to fit the controller permanently until the sun-
screening products and the sensors have been registered
in the controller.
However, date and time are only saved for 30 seconds
after disconnection of mains supply.
2
Select language:
Press to highlight your language.
Press "Enter" to confirm your choice.
14 VELUX
language
Dansk
english
Français
Deutsch
Enter
P1
ENGLISH
3
Set time the first time the controller is to be used:
Press to set minutes.
Press "Enter" to change to hours.
Press to set hours.
Press "Enter" to confirm your settings.
time is automatically switched from summer time to
standard time and vice versa (Western European sum-
mer time) but this function can be disabled, see section
Time and date.
Date is set correspondingly.
P2
Enter
P1
ENGLISH
set time
11: 0 0
Back
P2
VELUX 15