Alarm Setting - Medipost-Nutristoma MD300K2 Mode D'emploi

INSTRUCTION MANUAL

5.2 Alarm Setting

Pick the [Alarm Setting] interface from the main menu.
Before setting, please enter password (1234) to set the parameter. Or you can direct access
to check the parameter but not to change.
How do you input passwords?
1. Press the Navigation button to change the numbers.
2. Press the OK button to confirm the number.
3. Press the Navigation button switch to the next numbers.
4. Press the OK button to confirm your selection.
5. Repeat the step one.
How to change the passwords?
In the measuring interface, hole and press the menu button for 5s to change the passwords.
The first time, enter the old passwords.
The second time, enter the new passwords.
Then you can change the passwords.
Notes:
1. The read-only password is 0000. Under this password, you can only check the parameter
but not change.
2. The make-changes password is 1234, enter this password, you can set the parameters.
3. You can change the password. If you forget the password, Please choose "Factory Default"
in System Setting, the password will Recover to factory password (1234) .
4. Every time enter into the Alarm Setting in the main menu, Alarm Volume and Alarm Pause
in the System Setting, you should input the password.
Finger off
% PR
SpO
2 bpm
100 100
090 088
Enter the password
0 0 0
OK 09:31
Fig.5.3
- 13 -
0
OK
Back
MD300K2