JB Systems DYNASPOT Mode D'emploi page 6

ENGLISH
MAIN MENU:
 To select any of the functions, press the MODE button and use the DOWN / UP buttons to browse the
menu.
 Select the function with the ENTER button (the display blinks).
 Use DOWN and UP buttons to change the mode.
 Once the required mode is selected, press the ENTER button to select.
 Press the MODE button for about 2 seconds to store the setting and to return to
running mode. If you don't do this, the setting will not be stored and after about 8
seconds, the fixture will return to the previous running mode.
DMX Address [Addr]
Used to set the starting address in a DMX setup.
 Press the MODE and UP/DOWN buttons until "Addr" is shown on the display.
 Press the ENTER button.
 Use DOWN and UP buttons to change the DMX512 address.
 Once the correct address shows on the display, press the ENTER button to
select it.
 Press the MODE button for about 2 seconds to store the setting and to return to
running mode.
Channel mode [ChMd]
Used to set the desired channel setup mode.
 Press the MODE and UP/DOWN buttons until "ChMd" is shown on the display.
 Press the ENTER button.
 Use DOWN and UP buttons to choose 5MSL, 8CH or 10CH mode.
 Once the desired channel setup mode shows on the display, press the ENTER
button to select it.
 Press the MODE button for about 2 seconds to store the setting and to return to
running mode.
Show Mode [ShMd]
Used to choose the Show mode when used in standalone or master/slave.
Press the MODE and UP/DOWN buttons until "ShMd" is showing on the display.
 Press the ENTER button.
 Use DOWN and UP buttons to select one of the available shows:
 Sh 1: (Show 1) Fixture is placed on the floor. Tilt movement angle 210°.
 Sh 2: (Show 2) Fixture is fixed under ceiling. Tilt movement angle 90°.
 Sh 3: (Show 3) Fixture is placed on a podium, in front of the audience.
The spot is always projecting to the audience's direction; i.e. in front of the
stage. Pan movement angle (left to right to left): 160°. Tilt movement angle:
90° (60° above horizon; 30° below horizon.)
 Sh 4: (Show 4) Fixture is fixed under ceiling on the stage. The spot is
mainly projecting in front of the stage. Pan movement angle (left to right to
left):160°. Tilt movement angle: 90° (vertically, front 75°; back 15°)
 Once the desired mode is shown on the display, press the ENTER button to
select it.
 Press the MODE button for about 2 seconds to store the setting and to return to
running mode.
Slave Mode [SLMd]
Used to make the slave unit work in opposite to the master or to work in
complete sync.
 Press the MODE and UP/DOWN buttons until "SLMd" is shown on the display.
 Press the ENTER button.
 Use DOWN and UP button to select Slave1 (normal) or Slave2 (2 light show)
mode.
 Once the right mode is shown on the display, press the ENTER button to select it.
 Press the MODE button for about 2 seconds to store the setting and to return to running mode.
JB SYSTEMS
®
4/59
USER MANUAL
DYNASPOT