Maintenance And Cleaning; Changing The Fuse; Disposal - VOLTCRAFT 8202 Notice D'emploi

8. Maintenance and cleaning

The function generator is maintenance-free apart from replacement of fuses and occasional cleaning.
Use a clean, lint-free, antistatic and dry cloth to clean the device. Do not use any abrasive or chemical
agents or detergents containing solvents.
To clean the display, use a soft, clean and lint-free as well as antistatic and slightly damp cleaning cloth.
Switch the function generator off prior to cleaning or changing fuses and separate
it from all measuring cables. Also remove the mains cable.

8.1. Changing the fuse

If it is no longer possible to switch on the device, the mains fuse is probably defective.
Proceed as follows to replace the mains fuse:
• Switch the function generator off and remove all measuring cables and the mains cable from the device.
• Unlock the fuse holder on the rear (20) with a screwdriver by slightly pressing counter-clockwise. The
bayonet catch of the fuse holder opens. Remove the fuse holder.
• Replace the defective fuse with a new fine-wire fuse (5 x 20 mm) of the same type and nominal current
(F200mA/250V (quick)).
• Press the fuse holder back in and lock it by slightly pressing clockwise.

9. Disposal

Used electronic devices are raw materials and should not be disposed of in the household
waste. When the device has reached the end of its service life, dispose of it in accordance
with the current statutory regulations at the communal collection points.
It is forbidden to dispose of it in the household waste.
You thus fulfil your statutory obligations and make your contribution to the protection of the
environment.
35