Disposal; Care And Cleaning; Replacing The Fuse - VOLTCRAFT VLP-USB Série Mode D'emploi

A display accuracy
Operating voltage
Power consumption (max.)
Slow-blow mains fuse (5x 20 mm)
Operating temperature
Rel. humidity
Protection class
Mains connection
Weight
Dimensions (W x H x D)

7. Disposal

Electronic devices are recyclable waste and must not be placed in household waste. At the end of its
service life, dispose of the product according to the relevant statutory regulations.

8. Care and cleaning

Apart from an occasional cleaning or exchanging the fuse, this laboratory power supply is maintenance-free. Use a
dry, clean, lint-free, antistatic cloth to clean the device. Do not use any abrasive or chemical agents or detergents
containing solvents.

8.1. Replacing the fuse

If it is no longer possible to switch on the laboratory power supply, the rear mains fuse is probably defective.
Proceed as follows to replace the mains fuse:
• Switch the power supply unit off and remove all connecting cables from the device. Pull the mains plug from the
mains socket.
• Using a suitable slotted screwdriver, depress the fuse holder on the rear a little, and remove it with a quarter-turn
anticlockwise rotation (bayonet cap).
• Replace the defective fuse with a new fine-wire fuse (5 x 20 mm) of the same type and rated current: The fuse rating
is listed in the technical specifications.
• While pushing, screw the fuse plug clockwise back into the fuse holder until it clicks into place.
≤±(2% + 0.02 A)
230 V/AC (±10%) 50 Hz
590 VA
T3, 15 A/250 V
+5 to +40 °C
max. 85%, non-condensing
Low-power device installation socket, IEC 320 C14
11.0 kg
440 x 125 x 270 mm
1
53