Join The Cabinets (Fig.33) - Arneg Astana LX Manuel D'installation Et De Service

Installati on
procedure
(Fig.6)
What to avoid
i
For correct disposal, the package consists of:
wood - polystyrene - polythene - PVC - cardboard.

15. Join the cabinets (Fig.33)

Step
1 Disassemble the shoulders (if present).
2 Positi on the cabinets side by side
3 Check that the alignment pins are inserted in the correct housings.
4 Join the uprights and the brackets, using the screws supplied
5 Reassemble the back panels and any other covering elements possibly supplied
05060194 01 05-2022
ATTENTION! Accidental opening of the doors. Injury.
Keep the doors closed and locked during installati on.
ATTENTION! Accidental opening of the doors. Tilti ng of the cabinet.
Injury.
MINI ASTANA LX:
• secure the cabinet with the anchoring brackets supplied (Fig.12)
• use dowels (not supplied) suitable for the type of wall and fl oor
Step
1 lift the counter safely
2 use suitable scissors to cut the clip ti ghtening straps-A-
3 remove the clips and the frame
4 lower and place the counter in the area of use
7 adjust the horizontal positi on of the cabinet using a spirit level (Fig.10)
check that all feet are into contact with the fl oor
8
For versions with a fl oor-mounted electrical panel, adjust the feet
to a height of 100 mm - Fig.15.
9 level the counter both in front and back
gently remove the protecti ve fi lm, eliminate glue residues with suitable
10
solvents
11 carry out the fi rst cleaning using neutral products and a soft cloth.
10 assemble the cabinet ti lted towards the wall by at least 10 mm (Fig.13)
• Install maximum 3 counters within the same power supply and cooling line
• Should you need to move the counter, the latt er must be levelled again.
Incorrect levelling
• Protect the gas connecti on pipes with the insulati ng sheath all the way
to the inside of the cabinet.
• Aft er connecti ng the cabinet, seal the outlets of the connecti on pipes
and cables.
• DO NOT use alcohol to clean the methacrylate parts (Plexiglass)
• DO NOT use abrasives or metal sponges
• DO NOT install the cabinet (Fig.11):
- in areas at risk of explosion
- in open air and therefore exposed to the elements
- near heat sources (direct sunlight, heati ng systems, incandescence
lamps, etc.)
- in the vicinity of air currents (close to doors, windows, air-conditi on-
ing systems, etc.) that exceed a speed of 0.2 m/s
• Dragging. Failure/deformati ons/tears
DO NOT drag/push the cabinet
Follow the instructi ons for safe handling.
Astana LX - Mini Astana LX
Acti on
Acti on
English
53