Getting Started; Preparing The Reservoir - Waterpik WP-360 Mode D'emploi

8

GETTING STARTED

Important! Turn Water Flosser
off and charge for 24 hours
before first use. Plug the cord into
any standard electrical outlet. Make sure you
push the switch into the "OFF" position before
charging. The unit will not charge if the switch
is in the "ON" position. See "Care of your
Waterpik Water Flosser" for guidance on how
®
to look after your battery. The Waterpik
Flosser will stay charged for up to 2 weeks
depending on use.
Important!
Turn off
Off

Preparing the Reservoir

Slide Water Flosser power handle into back of
reservoir and press firmly to snap into place.
Water
®
Lift flip top on reservoir and fill the reservoir with
lukewarm water.
Charge for 24 hours
before first use.
Inserting and Removing Tips
Insert tip into the center of
the knob at the top of the
Water Flosser handle. The
colored ring will be flush
with the end of the knob if
the tip is correctly locked
into place.
To remove the tip
from the handle, press
the tip eject button
and pull tip from
the handle.