Getting Started - Waterpik WF-05 Mode D'emploi

6

GETTING STARTED

Fill
ON
OFF
Align
1. 2.
Notch
3. 4.
1. 2.
Power
ON
ON
Floss
High Massage
OFF
Water ON
Powering the Unit
Plug the cord into an electrical outlet. If the outlet is controlled by a wall
switch, be sure it is turned on.
Preparing the Reservoir
Lift the reservoir lid, remove the reservoir from base, and fill with lukewarm
water. Replace the reservoir onto the base, press down firmly, close
reservoir lid.
Inserting and Removing Tips
Tip Insertion
1. Press top button on handle to release flip top.
2. Insert tip through top, align notches on tip and handle
(dots on tip and flip top will align).
3. Using thumb, press tip firmly into opening to click into place.
4. Close flip top. Check to ensure top is secured to handle prior to
water flossing.
Tip Removal
1. Press top button on handle to release flip top.
2. Firmly push tip through opening to click out of position.
Prime Unit (First Time Use Only)
Set pressure control dial on base to high (pressure setting No.10), point
the handle and tip into sink. Turn power and water ON until water flows.
Turn water and power off.
NOTE: A tablet does NOT need to be loaded into handle for priming.