Getting Started With Your Water Flosser; Powering The Unit - Waterpik WP-950 Mode D'emploi

6

GETTING STARTED WITH YOUR WATER FLOSSER

NOTE: All tips and brush heads not included in all models.
Replace Every 3 Months
Orthodontic Tip
Pik Pocket™ Tip
Plaque Seeker Tip
®
Sensonic
®
Standard Brush Head
Sensonic
®
Compact Brush Head

Powering the Unit

Plug the cord into an electrical outlet. If the outlet
is controlled by a wall
switch, be sure it is
turned on.
Preparing the
Reservoir
Lift the reservoir lid,
remove the reservoir,
and fill with lukewarm
water. Replace the
reservoir over the
base and press
down firmly and
close the lid.
BEST FOR
Braces
General Use
BEST FOR
Periodontal Pockets
Furcations
BEST FOR
Implants Retainers
Crowns General Use
Bridges
BEST FOR
Plaque Removal
BEST FOR
Plaque Removal
Remove
Fill
Replace Every 6 Months
Classic Jet Tip
Tongue Cleaner
Replacement tips can be purchased from
your local distributor, which can be found at
www.waterpik.com/intl.
Inserting and Removing Tips
Insert tip into the center of
the Water Flosser handle,
pressing down firmly until tip
clicks into place. The colored
ring will be flush with the top
of the handle if the tip
is correctly locked into
place.
To remove tip from the
handle push the tip eject
button on the handle.
CAUTION: Do not press
tip eject button while
unit is running.
BEST FOR
General Use
BEST FOR
Fresher Breath
NO
gap
Tip
Eject
Button