Stacked Installation (Example Of 1 Vio-L210 Modules On Sub S118R) - dB Technologies VIO S118R Caractéristiques Techniques

STACKED INSTALLATION (EXAMPLE OF 1 VIO-L210 MODULES ON SUB S118R)

• For safety reasons, no more than 3 VIO-L210 modules may be mounted in a stacked
configuration on the DRK-210 fly-bar (2 subwoofers max). Alternatively, the AF-VIO1
frame can accommodate up to 3 stacked VIO-L208 modules (2 subwoofers max). For
other configurations, use additional safety straps (not provided).
• Use DBTECHNOLOGIES COMPOSER to set the design parameters.
• Place the accessory on the SUB 118R (installed on a level surface).
• Add the line-array modules one by one, at the previously calculated tilt angles as
illustrated in the
• Check that the local parameters of the various modules and subwoofers are set correctly
on the individual amplifier panels. Alternatively, you can remotely change all parameters
in real time or at a later time if you connect the line-array via the RDNet network
(DBTECHNOLOGIES NETWORK, AURORA NET). However, it is good practice to physically
copy at least the initial design setting onto the VIO-L210 modules before installation. For
further information, see the
• Make the audio, RDNet and power supply link connection as described in the previous
paragraphs (step B).
VIOS118R, DRK-210, VIO-L210
VIO-S118R
46
MECHANICS paragraph.
CONFIGURATION PARAMETERS section.
VIOS118R, AF-VIO1, VIO-L208
Cod. 420120271 REV. 1.0
English