dB Technologies VIO S118R Caractéristiques Techniques page 36

English
LED TYPE DURING SPEAKER
POWER-UP
LIMITER OFF
OFF
SIGNAL
MUTE/ ON FOR A FEW
PROT SECONDS
READY OFF
10. RDNet NETWORK INPUT CONNECTOR ("Data In")
For network cables with etherCON/RJ45 connectors.
Connect it to devices such as RDNet Control 2 or Control 8 for remote control.
11. RDNet NETWORK LINK CONNECTOR ("Data Out")
Compatible with network cables that have etherCON/RJ45 connectors.
Used to link the remote control network to other system modules in a daisy-chain configuration.
12. CONTROL LEDS
LEDs related to the network (RDNet) operating status.
Specifically, when "Link" is on, it means that the RDNet network is active and has recognised the device, "Active"
flashing means that there is data traffic, "Remote Preset Active" means that all local controls on the amplifier
panel have been bypassed by the RDNet remote control.
13. SYSTEM TEST
Carries out a test using a sweep signal to check that the woofer is in good working condition. This test should not
be considered exhaustive, but just a first troubleshooting check.
14. USB DATA SERVICE
Type B USB port, only to be used for updating the product firmware. See the
for further information.
VIO-S118R
DURING NOR-
MAL
OPERATION
OFF,
TURNS ON ONLY
WHEN LIMITER
TRIGGERS
FLASHES
WHEN THERE IS A
SIGNAL
OFF
ON
CONTINUOUSLY
Status LED indication table
GENERIC BLOCK DUE TO
WARNING SPEAKER FAULT
MOMENTARY FLASHES
FLASH CONTINUOUSLY
NORMAL OFF
INDICATION OF
AUDIO AT INPUT
MOMENTARY ON CONTINUOUSLY
FLASH
ON CONTINUOUSLY OFF
"UPDATING THE FIRMWARE" section
Cod. 420120271 REV. 1.0
35