Input, Output And Control Section - dB Technologies VIO S118R Caractéristiques Techniques

INPUT, OUTPUT AND CONTROL SECTION

1. AUDIO INPUT ("Balanced audio Input")
Input compatible with balanced XLR cables. Used to input the audio signal from the mixer, or from another
speaker or subwoofer in a daisy chain configuration.
2. AUDIO LINK ("Link/Xover Out")
Output compatible with balanced XLR cables. Used to link the audio signal to other VIO S118R subwoofers in a
daisy-chain configuration.
3. AUDIO SIGNAL ATTENUATION ("Subwoofer Attenuation)
Lets you adjust the subwoofer attenuation.
Set to 0 dB before starting to configure the subwoofer and system.
4. DELAY CONTROL ("Delay" [ms])
The two rotary selector switches let you set the output signal delay in the range 0–9.9 ms. One selector switch sets
the integer value of the delay and the second sets the decimal value.
5. POLARITY SELECTOR SWITCH ("Polarity")
Lets you invert the subwoofer polarity. This can be useful to align the phase of several subwoofers with each
other, or that of one subwoofer with the line-array modules. For any further details, see the
PARAMETERS chapter.
6. CARDIOID MODE SELECTOR SWITCH ("Cardioid preset")
A single control to configure for cardioid use. When this mode is selected, the "Active" LED is on and the polarity
and delay settings are bypassed.
7. LINK/XOVER SELECTOR SWITCH ("Link/Xover Out")
This determines the output type at the connector [2].
8. XOVER FREQUENCY SELECTOR SWITCH ("Xover [Hz]")
Selects the XOVER frequency (70-75-80-85-90-95-95-100-105-Fullrange) applied to the output [8]. The Service/User
position is used for the firmware update status or to recall a USER setting (see the DBTECHNOLOGIES NETWORK
manual). See also the UPDATING THE FIRMWARE
9. STATUS LED ("Status")
LEDs related to the module operating status. A table on the following page briefly summarises the meanings of
the various LEDs.
VIO-S118R
34
section.
English
CONFIGURATION
Cod. 420120271 REV. 1.0