ARIETE Evo 2 in 1 Mode D'emploi page 10

EN
installed attachment first, by removing it outward and then position the end of the dust container
(F) in the lower side of the apposite housing in the appliance body (M) and slightly push backward
the handheld vacuum cleaner until it clicks into place (Fig. 6).
WARNING: Make sure the handheld vacuum cleaner is properly installed before proceeding
with a new use.
CLEANING
- Clean the appliance body (M) and the removable body (C) by using only a damp cloth with mild
detergent, if necessary.
Proceed with care to prevent any kind of liquid from getting into the appliance.
Never use strong cleaning agents (stain removers, solvents) that may corrode the plastic.
How to empty the dust container (F)
WARNING: Clean the dust container (F) and the filter (D) in due time. The suction power is reduced
when the container is full or the filter is obstructed.
- From the back of the appliance, check whether the dust container (F) is full (Fig. 7).
- Remove the handheld vacuum cleaner as previously described.
- Press the unlocking button and remove the complete container (Fig. 8).
- Remove the filter (D) outwards (Fig. 9) and the related support (E) to clean them.
WARNING: Wash the filter (D) only with fresh water without using soap or detergents.
- Empty the dust container (A) into an apposite plastic bag and wash it with water, if necessary.
- Let the components dry and reassemble.
WARNING: Properly assemble the support (E), the filter (D), and the dust container (F) before start-
ing the appliance.
- Reassemble the appliance and store it using the apposite rear cord winder (N) - Fig. 10.
- If necessary, the handle can be tilted back by pressing the apposite button (O), Fig. 11.
- 8 -