Setting The Alarm - Sangean DDR-36 Mode D'emploi

Setting an alarm
. Press and release the Alarm  button. 'Alarm  Setup' will show on the display. Or Press and
release the Alarm  button. 'Alarm  Setup' will show on the display.
. Press the Select button to enter the alarm setup wizard. Alarm status will flash on the display.
. Rotate the Tuning control to select On or Off. If Off is selected any current setting for that
alarm will be cancelled.
4. With 'On' selected, press and release the Select button to cause the alarm hour digits to flash
on the display.
5. Rotate the Tuning control to choose the desired hour for the alarm and then press the Select
button to cause the alarm minute digits to flash on the display. If the radio has been set to the
 hour clock format, there will also be an option here for setting AM or PM for the alarm time.
6. Rotate the Tuning control to choose the desired minute for the alarm and then press the Select
button. The alarm duration will flash on the display.
7. Rotate the Tuning control to choose the alarm duration. Choose between 5, 0, 45, 60 or 90
minutes.
8. Press and release the Select button to enter the alarm duration. The alarm source option will
flash on the display.
Alarm 1 Setup
Alarm 1 Wizard
Alarm On
Alarm 1 Wizard
On time 09:00
Alarm 1 Wizard
On time 09:30
Alarm 1 Wizard
Duration 60
GB
4