Manual Tuning - Fm - Sangean DDR-36 Mode D'emploi

Manual tuning - FM

. Fully extend the aerial located on the rear of your radio.
. Press the Standby button to switch on your radio.
. Press and release the Mode button until the FM band is selected.
4. Rotate the Tuning control to tune to a station. The frequency will change in steps of 50kHz. If
the radio is tuned to a station of sufficient signal strength with RDS information present, then
the display may change to show the station name.
5. When the waveband end is reached the radio will recommence tuning from the opposite waveband
end.
6. Set the Volume to the desired setting.
7. To switch off your radio press the Standby button.
5
FM Mode
87.50MHz