Step 17 Dishwasher Wet Test; Step 18 Replace Toekick; Step 19 Literature; Custom Panel For Models Zbd6890, Zbd0700 - GE Monogram ZBD6800 Instructions D'installation

Installation Instructions/Custom Panel Dimensions
STEP 17
DISHWASHER WET TEST
Turn on power supply (or plug power cord into outlet, if
equipped).
Start the unit to check for leaks.
– Push RINSE ONLY pad.
– Push START/RESET pad one time.
– Close door.
Check to be sure that water enters the dishwasher. If water
does not enter the dishwasher, check to be sure that water
and power are turned on.
Check for leaks under the dishwasher. If a leak is found, turn
power supply off, then tighten connections. Restore power
after leak is corrected.
Check for leaks around the door. A leak around the door
could be caused by door rubbing or hitting against adjacent
cabinetry. Reposition the dishwasher if necessary. See Step 12.
The dishwasher will drain and turn off about 5 minutes after it
was started. Check drain lines. If leaks are found, turn power
off at the breaker and correct plumbing as necessary. Restore
power after corrections are made. See Step 15.
Open dishwasher door and make sure most of the water has
drained. If not, check that disposer plug has been removed
and/or air gap is not plugged. See Step 14. Also check drain
line for kinking.
Run the dishwasher through another "Rinse Only" cycle.
Check for leaks and correct if required.
STEP 18
REPLACE TOEKICK
• Place toekick against the legs of the dishwasher.
T o e k i c k
Attachment Screws
Figure II
• Align the toekick with the bottom edge and make sure it is
against the floor.
• Insert and tighten the two toekick attachment screws. The
toekick should stay in contact with the floor.
TIP: Make sure toekick is against floor to minimize noise.
STEP 19
LITERATURE
• Be sure to leave complete literature package and installation
instructions with the consumer.
CUSTOM PANEL FOR MODEL
ZBD6890, ZBD0700
These dishwashers require a field installed 3/4" thick custom
panel and custom handle. An installation template is packed
with these models and may be obtained in advance. Order
Pub. No. 31-30569-1. Complete panel installation instructions
are included on the template.
CUSTOM PANEL SIZE REQUIREMENTS
HEIGHT
Panel height must be between 30-1/16" and 30-1/4".
• If the panel height is more than 30-1/4" it will prevent the door
from swinging open.
• If the panel height is less than 30-1/16" it will not cover the
dishwasher door frame.
• The top of the custom panel must be flush with the top of the
door. The 1/2" minimum gap between the top of the door and
the bottom of the countertop must be maintained.
Minimum 1/2" Gap
for Clearance
WIDTH
Panel width must be 23-3/4".
• If the panel width is less than 23-3/4" it will not cover the
dishwasher frame.
IMPORTANT: To ensure optimum door balance performance,
the custom panel must not weigh more than 14 lbs.
15
30-1/16" Min.
30-1/4" Max.
23-3/4"
Countertop
1/2" min.