Step 2 Remove Wood Base, Install Leveling Legs; Step 3 Remove Toekick - GE Monogram ZBD6800 Instructions D'installation

STEP 2
REMOVE WOOD BASE,
INSTALL LEVELING LEGS
IMPORTANT
Do not kick off wood base! Damage
—
will occur.
• Move the dishwasher close to the installation location and lay it
on its back.
• Remove the four leveling legs on the underside of the
wood base with an adjustable wrench or 15/16" socket.
• Discard base.
Figure H
• Screw leveling legs back into the dishwasher frame,
approximately 1/4" from frame as shown.
STEP 3
REMOVE TOEKICK
• Remove the two toekick screws.
Figure J
Installation Instructions
Approx.
1/4"
Remove 2
Toekick Screws
8
STEP 4
INSTALL POWER CORD
Use Power Cord Kit WX09X70910 available for purchase from an
authorized GE Appliances dealer.
Skip this step if dishwasher will be direct wired or has a
factory installed power cord.
The power cord and connections must comply with the National
Electrical Code, Section 422 and/or local codes and ordinances.
• Maximum power cord length is 4 feet beyond the back of the
dishwasher.
B
A
Insert Power
Remove
Cord Wires Thru
Junction Box
Strain Relief
Cover
and Tighten
Ground
C Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Small Hole in Bracket
Figure K
• Connect incoming power cord white (or ribbed) to dishwasher
white, black (or smooth) to black and ground to dishwasher
green wire. Use UL listed wire nuts of appropriate size.
• Replace junction box cover. Be sure wires are not pinched
under the cover.
STEP 5 INSTALL 90° ELBOW
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
Front of Dishwasher
90°
Elbow
Figure L
• Do not overtighten 90° elbow, water valve bracket could bend
or water valve fitting could break.
• Position the end of the elbow to face the rear of the dishwasher.
White
D
Use UL Listed
Wire Nuts
Water Valve
Bracket
Fill
Hose
Thread
Seal Tape
Black