Operation - Diehl Metering SHARKY 775 Instructions D'installation

Deutsch
English
Information loop (3)
Sequence Window 1
3.1 Current date
3.2 "Sec_Adr"
3.3 "Pri_Adr 1"
3.4 "Pri_Adr 2"
3.5
3.6 "Port 1"
3.7 "Port 2"
3.8
3.9 Software version
Pulse loop (4)
Sequence Window 1
4.1 Pulse input 1
4.2 Pulse input 2
4.3 Pulse output 1
4.4 Pulse output 2
Tariff loop (5)
1
Month loop (6)
Sequence Window 1
6.1 "LO6"
6.2 "LO6"
: :
6.24 "LO6"
* Example Only for heat meters with activated cooling tariff
1 1
8.

Operation

Use the push button to page through the individual displays. A differenti-
ation is made between pressing the button for a short time and pressing
it for a long time. With a short button press (<3 seconds) you get to the
next display within a loop; with a long button press (>3 seconds) you
get to the next display loop. The "Energy" window (sequence 1.1) of the
main loop is the basic display. If the button is not pressed for approx. 4
minutes, the meter automatically switches off the display to save power
(exception: an error exists). If you press the button again, the meter
returns to the basic display.
Français Español
Window 2
Time
Secondary address
Primary address 1
Primary address 2
"coldPIPE" * (installation location)
0* (no. of the plugged in module at port 1)
1* (no. of the plugged in module at port 2)
"UHF ON" (status of integrated radio)
Check sum
Window 2
Cumulative value pulse
input 1
Cumulative value pulse
input 2
Pulse rate pulse output 1
Pulse rate pulse output 2
Window 2
Date of last month Energy
Date of month - 1
:
Date of month - 23 Energy
Window 3
Pulse rate
Pulse rate
Window 3 Window 4
Volume
Energy Volume
: :
Volume
-31-