Batteries; Precautions; Technical Specifications; Declaration Of Conformity - Tinyloc R2 FINDER Manuel D'instructions

10. BATTERIES

- The receiver operates on 4 x 1.5 V, AA alkaline batteries or 4 Lithium batteries.
- Do not use rechargeable batteries, they are not optimal for the operation of the R2 Finder.
- When the battery indicator shows a low level, do not wait until the batteries are exhausted,
replace them as the receiver will lose power.
- To change the batteries unscrew the screws of the lid with a flat screwdriver. Withdraw the lid
and extract the batteries. Introduce the new batteries in the position that indicates the sketch
of the bottom of the battery space. Place the lid and screw on the screws.

11. PRECAUTIONS

- Do not use sharp objects when replacing the batteries. There are electronic circuits below
the battery compartment which could be damaged.
- If the receiver is not going to be used for a while, remove the batteries to avoid deterioration
and any damage they might cause.
- Humidity seriously damages the receiver. Make sure the receiver and case are completely
dry before storing.

12. TECHNICAL SPECIFICATIONS

Power supply
Receiver Sensitivity (IEE MDS
Standard)
Frequency range
Operation temperature
Storage temperature
Protection rating
Weight
Consumption

13. DECLARATION OF CONFORMITY

http://www.tinyloc.com/declarationofconformity
75
6 volts (4 x LR6 "AA"). Do not use rechargeable
batteries
-146 dBm
UE/AUS/NZ (433.050-434.750 MHz)
-15º to 50ºC
-20ºC to 70ºC
IP20
520 g. with batteries
70-190 mA