Accessory And Hose Storage; Tug-A-Long Hose; Car Nozzle; G Extension Wands - RIDGID WD19560 Mode D'emploi

Operation (continued)
1. Locate blowing port of your Vac.
2. Insert the locking end of the tug-along
hose into the blowing port of the Vac.
The hose should snap into place. To
remove the hose from the Vac, press
the release button in the hose
assembly and pull the hose out of the
Vac inlet.
3. (Optional) Attach extension wand to
opposite end of hose, then place the
car nozzle on the wand.
4. Turn Vac on and you are ready to use
your Vac as a blower.
Accessory and Storage
Your accessories may be stored in the
removable tote, or in the two locations on
the caddy right/left. The hose may be stored
by wrapping it around the unit and placing
each end into the two areas marked Hose
Storage.
NOTE: Insert male end of extension
wand into the holder sleeve as shown.
The hose may be stored by wrapping it
around the unit and plugging the open
end into one of the storage locations on
the caddy assembly.
Tug-A-Long
Hose
Extension
Wand
(Optional)
13
Blowing
Port
Swivel
End of
Hose
Car Nozzle (Optional)
Accessory Storage
Compartment
Extension
Wand
Extension
Wand
Storage
Hose Storage
Area