Cord, Hose & Accessory Storage - RIDGID 4500RV0 Mode D'emploi

SP6951 RIDGID 4.5 Gallon-ESF_SP6609 1/16/15 8:49 AM Page 7
Cord, Hose & Accessory Storage
1. Your Vac has convenient locations to
store your power cord, Vac hose, and
accessories.
2. Under the left cover of your Wet/Dry
Vac (as shown) is a storage location
meant to hold your superflex hose,
crevice tool and power cord. For ease
of storage, the hose should be folded
as shown and placed in the storage bin
to the far left. You will also notice a
rectangular feature in the bottom of this
bin. The crevice tool will easily store
standing up in this feature, tapered
side down. Additionally, the power cord
will also fit in this bin to the far right
side. Fold or wrap the cord in
approximately 1-foot lengths until you
get within a foot of the storage bin. The
folded cord should now fit neatly into
the storage bin.
3. Under the right cover of your Wet/Dry
Vac (as shown) is a storage location for
the dusting brush and utility nozzle.
Each of these nozzles has a specific
location molded into the housing. Only
these two nozzles should be stored in
this location. Also located inside this
compartment is the blowing port.
Please see the "Blowing" section for
blowing directions.
4. To store the extension wands, snap
each extension wand into the extension
wand clips on the back of the unit.
Correct
Hose
Wrap for
Storage
Hose
Storage
Crevice
Tool
Storage
Power Cord
Storage
Extension
Wand Clip
7
Blowing
Port
Utility
Nozzle
Storage
Dusting
Brush
Storage
Extension
Wand