Wet/Dry Vac Assembly; Insert Hose - RIDGID WD19560 Mode D'emploi

Drum/Caddy Assembly (continued)
7. Insert the caster stem into the socket of
the caster foot as shown. (Front
casters only).
8. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will be able to hear the
ball snap into the socket and the caster
will swivel easily when positioning is
correct.
Caster Stem
Caster Ball
Socket

Wet/Dry Vac Assembly

1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Drum
Latch
Latch
Drum
Latch
Handles
Drum
9. Rotate drum/caddy assembly upright,
using a long phillips screwdriver, install
(8) #10 x 3/4" screws into matching
holes on both right and left side of
caddy. Tighten screws until just snug.
Do not over tighten as this may tend to
deform the caddies.

Insert Hose

Insert the push button end of the "Tug-A-
Long" hose into the inlet of the Vac. The
hose should snap into place. To remove
the hose from the Vac, press the release
button in the hose assembly and pull the
hose out of the Vac inlet, as shown.
Press
and
Pull
10
#10 x 3/4"
Screw (8)
Release
Button