Product Description; Transport; Technical Data; Installation And Assembly - Dea TEO 700 Notice D'emploi Et Avertissements

2 PRODUCT DESCRIPTION

Models and contents of the package
Under the name TEO 700 is identified a family of 24V electromechanical operators with built-in control board for adjusting the
forces while opening/closing and for managing optional features such as photocells, automatic closing, etc. .. Functions OPEN -
CLOSE - STOP operated by a single key, change of direction when an obstacle is detected in closing, led courtesy light in opening
and closing with auto-off after 3 minutes, protective functions for inputs in low and high voltage, short circuit, etc. .
TEO 700 is an electromechanical operator for the automation of sectional, overhead counterweight and spring doors. It is ba-
sically made up of a mechanical operator rotating the draft gear that, through a chain, transmits the movement directly to the door
draft system thus moving it.
Inspect the "Content of the package" (Pic. 1) and compare it with your product for useful consultation during assembly.

Transport

TEO 700 is always delivered packed in boxes that provide adequate protection to the product, however, pay attention to all
information that may be provided on the same box for storage and handling.

3 TECHNICAL DATA

Power supply (V)
Rated power transformer (VA)
Fuse F2 (A) (transformer)
Auxiliaries power supply output
Flashing light output
Receiver frequency
Transmitters type of coding
Max remote controllers managed

4 INSTALLATION AND ASSEMBLY

4.1 For a satisfactory installation of the product is important to:
• Ensure the door frame is solid and suitable to be driven;
• Make sure that during its movement it doesn't present friction points;
• Check it is well balanced. If required adjust the balancing mechanisms;
• Foresee an adequately protected 230V socket near the automation.
4.2 Defined and satisfied these prerequisites, proceed to the assembly:
• Slide the sliding block externally the track and add it to the chain (Pic. 3); Then place it half of the track;
• Join the profile to the main unit by passing the chain over the pinion of the motor and blocking the whole with the fixing omega
(Pic. 4). If the profile swings too, provide an additional fixing point at about 1mt. from the door;
• Acting on the tensioner, put a little tension on the chain (Pic. 5);
• Secure the rail to the door frame (if possible) or to the wall with screws or bolts suitable to the material according to a distance of
40mm from the maximum run of the door (Pic. 6);
• Then check the measures for drilling and proceeds to mount of TEO 700 (Pic. 7) to the ceiling.
4.3 How to unlock the operator
All TEO 700 models are equipped with a release device that is activated by pulling down on the handle shown in Pic. 8, now if
no obstructions hinder its movement, the door can now move freely. The door will be locked again automatically with the first travel
thus returning the operator to its normal working conditions.
10
CONTROL BOARD
230 V ~ ±10% (50/60 Hz)
100 VA (230/22V)
2,5A 250V
+24 V max 200mA
24 V max 15W
433,92 MHz
HCS rolling code
20
TEO 700
Motor power supply voltage (V)
Absorbed power (W)
Max Thrust (N)
Work cycle (cycles/hour)
Maximum n° of operations in 24 hour
Operating temperature range (°C)
Opening speed (m/min)
Weight of product with package (Kg)
Protection degree
OPERATOR
24 V
100
1000
15
35
-20÷50
9
4,3
IP30