Christie LHD700 Guide De Référence Rapide page 4

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS
INSIDE EXCEPT LAMP REPLACEMENT.
REFER SERVICING TO QUALIFIED SERV-
ICE PERSONNEL.
THIS SYMBOL INDICATES
THAT DANGEROUS VOLTAGE
CONSTITUTING A RISK OF ELECTRIC
SHOCK IS PRESENT WITHIN THIS
UNIT.
THIS SYMBOL INDICATES THAT THERE
ARE IMPORTANT OPERATING AND
MAINTENANCE INSTRUCTIONS IN THE
USER MANUAL WITH THIS UNIT.
SAFETY PRECAUTIONS
WARNING:
● THIS APPARATUS MUST BE EARTHED.
● TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
– This projector produces intense light from the
projection lens. Do not stare directly into the
lens, otherwise eye damage could result. Be
especially careful that children do not stare
directly into the beam.
– Install the projector in a proper position.
Improper positioning may reduce the lamp life
and result in severe accident or fire hazard.
– Allowing the proper amount of space on the
top, sides, and rear of the projector cabinet is
critical for proper air circulation and cooling of
the unit.
SIDE and TOP
1.5' (50 cm)
1.5' (50 cm) 1.5' (50 cm)
– Do not cover the ventilation slot on the
– If the projector is unused for an extended
– Do not project the same image for a long
time. The afterimage may remain on the
LCD panels by the characteristic of panel.
– Do not set the projector in greasy, wet,
Hot air is exhausted from the exhaust vent.
When using or installing the projector, the
following precautions should be taken.
– Do not put any flammable object or spray can
near the projector, hot air is exhausted from
the air vents.
– Keep the exhaust vent at least 1 m away from
any objects.
– Do not touch peripheral parts of the
exhaust vent, especially screws and
metallic parts. These areas will become
hot while the projector is being used.
– Do not put anything on the cabinet.
Objects put on the cabinet will not only get
damaged but also may cause fire hazard
by heat.
REAR
3' (1 m)
Not for use in a computer room as defined in the
Standard for the Protection of Electronic Computer/
Data Processing Equipment, ANSI/NFPA 75.
2
projector. Heat build-up can shorten the
service life of your projector, and can also be
dangerous.
time, unplug the projector from the power
outlet.
or smoky conditions such as in a kitchen
to prevent a breakdown or a disaster. If
the projector comes in contact with oil or
chemicals, it may become deteriorated.
Exhaust Vent
(Hot air exhaust)
Air Intake Vent
Authorized Representative and Address:
Christie Digital Systems Canada, Inc.
ViewPoint 200 Ashville Way Wokingham
Berkshire, U.K. RG41 2PL
Manufacturer and Address:
Christie Digital Systems Inc.
809 Wellington Street, North. Kitchener,
Ontario N2G 4Y7, Canada
CAUTION
Air flow
020-000424-01 Rev.1 (11-2011)