Mixer Section; Output Section; Mixer Section (Continued) - Cortex DMIX-600 Manuel D'utilisation

DMIX-600 MIXER SECTION
The integrated mixer section in the DMIX-600 is split into 5 sections-the
Input/Output section, Gain/EQ, Faders Microphone and Cue. Over the
next few pages we will go over the basics of each section and how to
use your DMIX-600 to both play songs internally as well as hook up
external equipment.

OUTPUT SECTION

Fig 7.9- Output section of the Dmix 600
The DMIX-600 has the ability to output to 3 sperate devices as well as
accept 2 stereo devices (Line or Phono level). The output section consists
of the following-
Master-The main output of your mixer. This is the output you will connect
to your amplifier, powered speakers or external mixing board and is
controlled by the MASTER rotary knob located just under and to the left
of the iPod dock.
Booth-Like the Master output, but to be connected to your monitoring
speakers and is controlled by the BOOTH rotary knob located just under
and to the right of the iPod dock.. Use this output for your speaker set in
the DJ booth.
Record-A third output, with no volume control and set to output at a con-
sistant level for recording. Use this to connect to a recording device.
Balanced XLR-The balanced XLR outputs mirror the MASTER output
except that are balanced for use in professinal installations, they are
also controlled by the MASTER rotary knob.
INPUT SECTION
Fig 8.1 - Input section of the Dmix 600
The DMIX-600 has the ability to accept up to two analog sources along
with it's two internal Digital channels from the connected USB MSD
devices. The input section consists of 2 analog RCA inputs, labeled Input
1 and Input 2. When used together with the Line/Phono switch on each
channel, these can accept either a line level source (CD Player, Cassette
Deck) or a Turntable with a Magnetic Cartridge. Set the switch to LINE if
you wish to connect a Line Level source. Set the switch to PHONO if you
wish to connect a Phono level source.
The Master and Booth controls
These two rotary knobs control the level of the MASTER output and the
BOOTH output levels.
Fig 8.0 - Master and Booth controls
Line and Cross Faders
The next section of the DMIX-600 is the mixer section are the Line and
Cross Faders. The Line fader is the Volume Control of your channel-use it
to adjust output volume of each individual channel. The Crossfader on
the other hand can be used to fade between each channel. The speed in
which the volume comes in on each side of the Cross Fader can be con-
trolled by the Fader Curve Switch, located above the Cross Fader.
The Crossfader is user relaceable, and can be ordered from any
Authorized Cortex dealer or from our own Tech Support department
Fig 8.2 - Crossfader/Linefader/VU section of the Dmix-600
Using the DMIX-600

Mixer Section

26