Cortex DMIX-600 Manuel D'utilisation page 11

1
2
3 4
5
6
7
8
15.JOG WHEEL
The JOG WHEEL controls many aspects of the unit, and can be used for
navigating through menus, searching through music and manipulation of pitch.
The behavior of the JOG WHEEL is dependent on the mode of operation, as
well as the status of the PITCH ON/OFF indicator and JOG MODE. The JOG
WHEEL is also touch sensitive allowing you to press down on it to stop the music
and/or manipulate your music like a vinyl turntable would.
16.CUE button/indicator
When the LED indicator which illuminates this button is lit, it indicates that there
is a CUE POINT memorized.
17.PLAY/PAUSE button/indicator
When the LED indicator which illuminates this button is lit solidly, it indicates that
the unit is in PLAY mode. When the LED indicator is flashing, it indicates that the
unit is in PAUSE mode.
18.LCD DISPLAY panel
This blue-backlit display is a 20 Character LCD that displays information such as
track/waveform, folders, parameter adjustments and search information.
Contrast is available in the Edit menu.
19.Hot Cue Section
There are two HOT CUES for each side and both can be made on the fly,
Additionaly by pressing SHIFT plus either CUE button you can edit the start time
of the CUE point.
20.NAVIGATOR keypad
These buttons allow the user to navigate through menus and features of the
Dmix-600. Depending on the mode of the unit, the buttons may serve different
purposes.
9
12
10
19
13
14
11
16
Top Panel & Functions
18
20 21
15
21.Master Tempo and Key Adjust buttons
These buttons engage functions that change how the pitch is used. Master Tempo
changes the speed without changing the pitch. Key adjust changes the key of the
song without changing the speed .Both Master Tempo and Key can be used in
combination. When Key Adjust is enabled then the PITCH BEND buttons act to
change KEY instead of acting as a PITCH BEND.
22.Pitch Fader, PITCH ON/OFF indicator and PITCH BEND buttons
This slide, when pushed towards the bottom of the unit (+), increases the tempo
of playback. When the slide is pushed towards the top of the unit (-), the tempo
of playback is decreased. The Pitch Bend buttons can be used to make tempo-
rary increases and decreases in pitch for matching tempo, and when both but-
tons are pressed together the pitch is turned on and off (as indicated by the
Pitch On/Off indicator LED).
23. Loop section
The loop function allows you to set an "IN point and an "OUT' point and repeat
(LOOP) whatever information is between those two points indefinitly. You also
have the abilty to adjust the "IN" point and the "OUT" point by simply pressing
SHIFT at the same time as either IN button or the OUT button, This will engage
the loop editor give you the abilty fine tune the loop to your desired result. At
anytime you can release or disengage the loop by pressing "OUT" again. Later
to recalll the loop you need only press the reloop button to re-engage the loop
from its original 'IN "point
Setup Guide
(Continued)
Top Panel
22
23
17
9