Loop Feature - Cortex DMIX-600 Manuel D'utilisation

.

Loop feature

The DMIX-600 can repeat or LOOP a segment of a song that is loaded
on either side, and will save that loop point so it can be recalled every-
time you load that song.*
* Loop points are saved to the storage device that was being used when you made the loop
and will only be recalled from that particular storage device
Set loop
To set the start point press the IN button once and the button will illumi-
nate indicating the IN point of the loop is SET (Fig A) on the display this
point is represented by a lowercase (i).
Then press the OUT button and the OUT button will illuminate indicating
that the loop is complete , the DMIX-600 will now continue to loop
between these two point indefinitely, this OUT point is represented by a
lowercase (o) on the corresponding display.
Edit loop points
Once the loop points are set you can adjust either the IN point or the OUT
point, press the SHIFT button and IN and the display will say PLEASE EDIT
IN POINT , which means you can use the JOG wheel to adjust the IN point
of the loop, likewise if you press SHIFT and OUT the display will say
PLEASE EDIT OUT POINT and you will be able to adjust the OUT point of
the loop. To exit this mode just press SHIFT and the button you were edit-
+
ing and the display should return to its previous position.
OR
+
Exit loop
To exit the loop and continue playing the song press the OUT button
again. (Fig C) and the song will continue playing. If you wish to RELOOP
or to re-engage the same LOOP press the RELOOP button (FIG D) and
the loop will start again continuing until The OUT button is pressed.
Erase loop
To erase the current loop press SHIFT and the R/LOOP button for two sec-
onds and the loop will be erased, also the IN and OUT buttons will turn
off, at this point you can create another loop. You can keep making as
many loops as you wish but the DMIX-600 will ONLYsave the last loop
you made with that particular song to the drive that the song was played
from. This feature must be turned on in the settings menu.
.
IN
OUT
Using the DMIX-600
Loop Feature
Fig A
Fig C
Fig B
Fig D
22