1 - General safety rules and precautions
A radio remote control is considered as a machine control
device. All applicable rules must therefore be observed to
ensure safe, correct operation of such devices.
For maximum safety when using the radio remote control, we
recommend that the operator carefully follows the instructions
provided in this manual.
IMPORTANT :
It is the installer's responsibility to make sure that the safety level
of this radio remote control is consistent with the risk presented
by the application. As may be required, the installer must check for
the presence of an emergency stop palmswitch on the equipment.
IMPORTANT :
Before use, it is indispensable to modify and to personalize the
setting of the transmitter and receiver to insure the uniqueness of
the installation (see chapter «Device configuration»).
If several radio controls are used on the same site, different radio
frequencies should be used, spaced by at least two channels (for
example, channels 5, 7, 9, etc.).
The more space there is between the chosen radio channels, the less
the risks of disturbance are (1).
The operator must be appropriately trained and certified to operate
machines by radio remote control.
The operator must have uninterrupted visibility of the manoeuvre
which he is performing. When the operator's direct field of view is
inadequate, the controlled equipment must be equipped with auxiliary
devices to improve visibility. When several machines are being
moved simultaneously, the equipment must be fitted out to limit the
consequences of a possible collision.
Battery replacement: the battery must be replaced by an instructed
person.
Service your equipment, and perform all periodic checks as may be
required by the intensity with which your equipment is used.
(1) = The programming of another radio channel number can only be done
with a transmitter equipped with an «On/Off» button.
FR
- 60 -
EN
DE
Orion - 324501J