Choice Of Operating Radio Frequency; Continuous Nc Or No» Relay Operating Mode; Minimum And Maximum Current Of Relay Outputs; Multifunction» Transmitters Equipped With Accumulators And Charger Support (Orcl•) - Orion OREL Notice D'installation Et D'utilisation

8.2- Choice of operating radio frequency

To ensure good operating quality, it is important that the radio channel used
be free throughout the area in which the machine will be controlled.
If several radio remote controls are operating on the same site, frequencies
spaced by at least two radio channels (for example: 5, 7, 9 ...) should be
used and, if necessary, a frequency plan should be drawn up, specifying
the various machines controlled and their working frequency.
8.3- «Continuous NC or NO» relay operating mode
If a system is used in continuous mode with the control buttons maintained
pressed and the operator moving about, transmission interruptions can
occur due to the dispersion and propagation of radiowaves which must be
taken into account in accordance with the application.

8.4- Minimum and maximum current of relay outputs

Be sure not to exceed the minimum and maximum characteristics specified
in chapter
additional load or intermediate relays (auxiliary contacts in electrical
cabinet for power control, for example).
8.5- «Multifunction»
accumulators and charger support (ORCL•)
When transmitters are equipped with accumulators, please charge them for
approximately 3 hours before a first use.
FR
- 102 -
Technical characteristics, by installing, if necessary, an
EN DE
transmitters equipped
Orion - 324501J
with