Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3E-490046NI – 10/20
ASSEMBLY ON INDIVIDUAL LEGS
The unit should be levelled using the adjustable feet (20mm spanner). Fig. 2.1A → 2.1C
ASSEMBLY CANTILEVERED OFF A WALL
The unit should be levelled using the adjustable feet (20mm spanner). Fig. 2.3A → 2.3F
The cantilever support must be able to take 400 daN (2 supports for an 1100 or 1400 unit). For units cantilevered off a concrete wall the
following are recommended:
* Reinforced concrete of a minimum quality of 23 MPA (DTU).
* Use rawl plugs such as HSA-R M 8 x 75 or equivalent.
* For the rawl plugs above the hole to be drilled should be 8 mm and to a depth of 65mm minimum.
ASSEMBLY ON A MASONRY PLINTH
The unit should be levelled using the adjustable feet (20mm spanner).Connect to electricity, gas, water and drain before fixing to the plinth
Fig. 2.4A → 2.4G
Dimension for a wall or central island plinth
Am
Wall plinth depth
710 (before floor tile)
A technical compartment is required if the stop cock, drain valve, or gas regulator are in the suite.
There are two solutions:
1) Neutral unit on a 200mm technical compartment.
2) A 400 tap cupboard with every possible cooing or neutral top, except induction.
Assembly of units on a masonry plinth
Wall
(side view)
Stove depth
Am
Finished
height with
Full tiled base
tiled front
1 cm/m maximum slope
Central island depth
1420 (before floor tile)
Ventilation
Page 3
LOCATING
Centrally
Stove depth
Full tiled base
1 cm/m maximum slope 1 cm/m maximum slope
(front view)
Lf: Stove width
Ls
Full tiled base
Plinth dimensions
Ac
Services could run
along the front
(side view)
Stove depth
Ac
Full tiled base
Ls
Finished height tiled to
Length
Lf-50
EN
Finished
height with
tiled front
the front
110
ELRO-Werke AG
Wohlerstrasse 47
5620 Bremgarten
Publicité
Table des Matières
