Instructions For Daily And Periodic Maintenance; Service, Spare Parts And Guarantee - Solo 694 Instructions D'emploi

Instructions for daily and periodic maintenance

To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be
performed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform
the prescribed maintenance work can lead to accidents!
Perform the following servicing work daily after use. Make a habit of it, it does not require much time and your saw will always function
properly.
Possibly hidden faults can be detected in this manner before causing expensive and annoying interruptions of your work. In case
you should detect a fault in the safety equipment when performing daily servicing, the saw must not be used before elimination of
the fault.
The user of the chain saw must not perform maintenance work which is not described in the Owner's Manual. All such work must
be carried out by a SOLO service center.
General work
Before each start
Every day
Every week
Every 3 months
Annually
Storage

Service, spare parts and guarantee

Maintenance and repair
The maintenance and repair work of modern engines as well as all safety related assemblies require qualified technical training and
the availability of a workshop equipped with special tools and testing devices.
We therefore recommend you to consult a SOLO service center for the performance of all work not described in this instruction
manual.
The SOLO service centers are provided with all the necessary equipment and skilled and experienced personnel to work out correct
customer solutions and to advise you in all matters accordingly.
Please contact your nearest service center. Should you however not have an adress for a SOLO service center then please contact
the SOLO general trading company (see last page) who will gladly provide you with the adress of your nearest SOLO service center.
46
Chain saw
Sprocket
Chain brake
Chain
Guide bar
Chain lubrication
Chain brake
ON/OFF switch,
Safety locking button
Throttle lever
Fuel/oil tank
plug
Air filter
Guide bar
Guide bar support
Idling speed
Fan housing
Carburetor interior and
cylinder ribs
Chain brake
Spark plug
Muffler
Vibration damper
Chain guide
Suction head
Fuel/Oil tank
Chain saw
Guide bar/chain
Fuel/oil tank
Oil pump
Carburetor
Clean the outside and check for damage.
In case of any damage have it immediately repaired by a
service center.
Replace in time.
Have it regularly checked by a service center.
Check for damage and sharpness.
Resharpen regularly, replace in time.
Check the chain tension.
Check for damage.
Functional check.
Functional check.
Functional check.
Check for tightness.
Clean.
Check for damage, clean oil intake bore.
Turn it over so that the bearing surfaces are equally worn.
Replace in time.
Clean, in particular the oil guide groove.
Check (chain must not run).
Clean to ensure a perfect cooling air supply.
For this the fan housing must be demounted.
Clean, for this demount cover and protective cover.
Clean the brake band (sawdust, oil)
Check and replace if necessary.
Tighten fastening screws, clean spark arrester screen
Check.
Check.
Replace.
Clean.
Check at an authorized service centre
Demount, clean and oil slightly.
Clean the guide groove of the guide bar.
Empty and clean.
Clean.
Run empty.
Page
26
24-25
19
21-22
22
22
21
28
21
25
23
27
25
28
26
29
27
25