Scope Of Application; Start-Up - First Use - Hozelock Green Power XL Mode D'emploi

manufacturer, their after sales
department or by people with similar
qualifications to avoid any danger. We
waive any liability in case of accident
caused by a use of the GREEN
POWER XL not complying with safety
instructions or beyond its scope of
application, or due to a modification
of the GREEN POWER XL or an
intervention on the electrical part.
A fire may result if the appliance is
not used with care, therefore:
Do not use the GREEN POWER XL
in an environment featuring risks
of explosion or near flammable
materials.
Do not use in an arid zone to prevent
risks of fire.
Do not direct the hot air towards
persons or animals.
Do not direct the hot air flow to the
same point for a rather long period.
Ensure the heat cannot propagate
to hidden flammable materials, and
ignite them.
After its use, lay the GREEN POWER
XL on its carrier (Fig1 item 7) safely
and leave it to cool down completely
before storing it.
Do not leave the GREEN POWER XL
running unattended.
Do not expose the GREEN POWER XL
to rain or humidity.
Do not immerse the GREEN POWER
XL in water.
Disconnect the device before
changing any accessories or storing it.
Do not touch the hot nozzle (Fig1 item 8,9).
Never obstruct the vents (Fig1 item 5).

SCOPE OF APPLICATION

The GREEN POWER XL is designed
for a private domestic use.
It eliminates weed by means of thermal shock. The fast
temperature build-up bursts the cells of the plant and
destroys the weed.
START-UP – FIRST USE
Starting up
Choose the round nozzle or the extra large nozzle for your
using.
Nozzle
treatment in the
Round lawn, vegetable
flowerbeds...
Treatment of the
paths, pavement,
Extra large
gravel path,
Assemble without tool the nozzle chosen with bayonet system
(Fig3).
Caution: Don't exchange, don't
dismount or don't assemble a
nozzle if GREEN POWER XL was just
used. Make sure that the product is
totally cold before to do these
operations.
Ensure the nozzle (8 or 9) is properly
fitted and the switch (4) is set to 'OFF'
(Fig2A). Connect the GREEN POWER
XL with the supply cable (3) onto the
power supply network after checking
the safety measures are observed.
Check that nothing is placed in front
of the nozzle when switching on the
GREEN POWER XL.
Start the GREEN POWER XL by
setting the switch to the 'heating'
position (Fig2B).
Hold the GREEN POWER XL with its
ergonomic handle (1).
Warm up the device for 45 seconds to
reach the operating temperature.
To eliminate weed, apply the nozzle
(8 or 9) onto it while letting it rest on
the ground for the duration indicated
in the table above. You simply need
to heat (whiten) the weeds until they
shrink back; there is no need to burn
the plant.
The plant cells will then dry and the
4
Duration of
Using the treatment
per plant
Localized
3-5 secondes
garden,
5-7 secondes
borders...
we
2 t
Th
an
No
ne
we
Be
co
req
Se
po
30
On
ca
sw
Eq
de
ba
ma
To
ch
an
few
Ma
po
cen
to
the
sta
30
on
is s
fla
Th
Un
fro
do
pa
of
or
Ch
be
Th