Publicité
Les langues disponibles
Les langues disponibles
Precautions for use
The current approval standards (ECE22-05) state that the minimum light transmittance levels must be greater than 80% when riding
at night and not less than 50% when riding during the day. For this reason, when riding during the day under particularly bright weath-
er conditions, e.g. very strong sunlight caused by high intensity and/or incidence of the sunbeams, the use of sunglasses - which have
a transmittance much lower than 50% - turns out to be advisable, if not absolutely necessary, to reduce eye fatigue on long trips.
Sunglasses reduce the risk of direct dazzling as opposed to the use of mere approved visors. However, the use of sunglasses makes
it difficult to perform in emergency situations when the maximum visibility range of the visor must be quickly restored. Just think, for
example, of what happens when you enter a tunnel or when unexpected changes in environmental brightness occur. Thanks to its
operating mechanism, the VPS makes these operations much easier.
WARNING
-
Sunshield does not comply to AS1609.
-
The VPS can be used only during the day and under the environmental conditions described before.
-
At night and/or in poor visibility conditions, the VPS MUST be deactivated.
-
Always check that the VPS is properly positioned according to the different weather/environmental conditions and/or to the above
mentioned recommendations for use.
-
We recommend using the VPS only and solely together with the approved standard visor, which has a transmittance value greater
than 80%.
-
Since the VPS does not assure you the same protection as the one provided by the visor, it has to be used only when the helmet
visor is pulled down.
-
Always make sure that the VPS is clean and that it is operating properly in order to avoid scratches and/or anomalous wear on it
every time it is activated.
-
Always check the correct VPS operation and in case of malfunctioning do not use the helmet and contact immediately a Nolan
authorized dealer.
-
Please refer to the proper section in the helmet user's manual for the VPS and visor maintenance and cleaning operations.
-
The VPS scratch-resistant and fog-resistant treatment highly reduces fogging. Protracted periods of adverse weather and/or envi-
ronmental conditions might cause fogging and/or formation of condensation on the VPS, which entails a reduction of visibility
and/or sharpness of vision: in this case, deactivate the VPS.
-
In case of rain, the direct contact of raindrops with the scratch-resistant and fog-resistant treated VPS quickly reduces sharpness
of vision, thus causing scarce visibility: in this case, deactivate the VPS.
-
The special VPS fog-resistant treatment is usually sensitive to high temperatures or heat sources. In this case, contaminations caused
by contact with other materials might occur. These contaminations will cause marks and stains to develop. In these cases (e.g. when
the helmet is kept in the top case on hot days), it is recommended to make sure the visor is not touching other materials.
Precautions for use
The current approval standards (ECE22-05) state that the minimum light transmittance levels must be greater than 80% when riding
at night and not less than 50% when riding during the day. For this reason, when riding during the day under particularly bright weath-
er conditions, e.g. very strong sunlight caused by high intensity and/or incidence of the sunbeams, the use of sunglasses - which have
a transmittance much lower than 50% - turns out to be advisable, if not absolutely necessary, to reduce eye fatigue on long trips.
Sunglasses reduce the risk of direct dazzling as opposed to the use of mere approved visors. However, the use of sunglasses makes
it difficult to perform in emergency situations when the maximum visibility range of the visor must be quickly restored. Just think, for
example, of what happens when you enter a tunnel or when unexpected changes in environmental brightness occur. Thanks to its
operating mechanism, the VPS makes these operations much easier.
WARNING
-
Sunshield does not comply to AS1609.
-
The VPS can be used only during the day and under the environmental conditions described before.
-
At night and/or in poor visibility conditions, the VPS MUST be deactivated.
-
Always check that the VPS is properly positioned according to the different weather/environmental conditions and/or to the above
mentioned recommendations for use.
-
We recommend using the VPS only and solely together with the approved standard visor, which has a transmittance value greater
than 80%.
-
Since the VPS does not assure you the same protection as the one provided by the visor, it has to be used only when the helmet
visor is pulled down.
-
Always make sure that the VPS is clean and that it is operating properly in order to avoid scratches and/or anomalous wear on it
every time it is activated.
-
Always check the correct VPS operation and in case of malfunctioning do not use the helmet and contact immediately a Nolan
authorized dealer.
-
Please refer to the proper section in the helmet user's manual for the VPS and visor maintenance and cleaning operations.
-
The VPS scratch-resistant and fog-resistant treatment highly reduces fogging. Protracted periods of adverse weather and/or envi-
ronmental conditions might cause fogging and/or formation of condensation on the VPS, which entails a reduction of visibility
and/or sharpness of vision: in this case, deactivate the VPS.
-
In case of rain, the direct contact of raindrops with the scratch-resistant and fog-resistant treated VPS quickly reduces sharpness
of vision, thus causing scarce visibility: in this case, deactivate the VPS.
-
The special VPS fog-resistant treatment is usually sensitive to high temperatures or heat sources. In this case, contaminations caused
by contact with other materials might occur. These contaminations will cause marks and stains to develop. In these cases (e.g. when
the helmet is kept in the top case on hot days), it is recommended to make sure the visor is not touching other materials.
7
7
Publicité
