Nolan N86 Sécurité Et Instructions D'utilisation page 4

INSTRUCTIONS FOR USE
• VISOR MECHANISM SYSTEM
1 DISASSEMBLY
1.1 Open the visor completely.
1.2 By pressing the visor release button (A), slide the visor forwards until you hear a click (Fig. 1).
1.3 Release the visor fastenings (B1 and B2) from their seat (Fig. 2).
1.4 Repeat the same steps on the other side of the helmet.
2 ASSEMBLY
2.1 Set the visor in open position by placing the visor fastenings (B1 and B2) into their seats in the visor mechanism (Fig. 2).
2.2 Insert fastening B1 in the housing provided and press the visor against the shell in line with fastening B2.
2.3 Slide the visor backwards until the visor locks into place.
2.4 Repeat the same steps on the other side of the helmet.
WARNING!
- After each assembly or disassembly procedure of the different parts, check that the visor mechanism works properly by pulling
the visor up and down; if necessary, repeat the steps described above.
- Do not remove the visor pulling up/down mechanisms from the shell.
- If the visor opening/closing mechanisms are not working properly or if such mechanisms get damaged, please contact a Nolan
authorized dealer.
•
(Available as standard or optional accessory)
1 PINLOCK ® INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjustment external levers are turned inwards.
1.3 Place the Pinlock ® inner visor on the visor. WARNING: The silicone-sealed profile of the Pinlock
with the inner surface of the visor.
INSTRUCTIONS FOR USE
• VISOR MECHANISM SYSTEM
1 DISASSEMBLY
1.1 Open the visor completely.
1.2 By pressing the visor release button (A), slide the visor forwards until you hear a click (Fig. 1).
1.3 Release the visor fastenings (B1 and B2) from their seat (Fig. 2).
1.4 Repeat the same steps on the other side of the helmet.
2 ASSEMBLY
2.1 Set the visor in open position by placing the visor fastenings (B1 and B2) into their seats in the visor mechanism (Fig. 2).
2.2 Insert fastening B1 in the housing provided and press the visor against the shell in line with fastening B2.
2.3 Slide the visor backwards until the visor locks into place.
2.4 Repeat the same steps on the other side of the helmet.
WARNING!
- After each assembly or disassembly procedure of the different parts, check that the visor mechanism works properly by pulling
the visor up and down; if necessary, repeat the steps described above.
- Do not remove the visor pulling up/down mechanisms from the shell.
- If the visor opening/closing mechanisms are not working properly or if such mechanisms get damaged, please contact a Nolan
authorized dealer.
•
(Available as standard or optional accessory)
1 PINLOCK ® INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjustment external levers are turned inwards.
1.3 Place the Pinlock ® inner visor on the visor. WARNING: The silicone-sealed profile of the Pinlock
with the inner surface of the visor.
4
4
® inner visor should be in contact
® inner visor should be in contact