HUUM DROP Mode D'emploi page 6

Table 2
DROP 4.5
DROP 6
DROP 9
NB! It is forbidden to use a non-heat-resistant cable with PVC isolation
as the power cable. The joint box must be waterproof and it must be
located up to 50 cm from the floor.
L1 L2 L3 N
400V 3N
• Open the cover of the heater's electrical box.
• Attach the power cable on the terminal block according to the
circuit diagram.
• Close the cover.
• Fix the cable on the output with a cable strap.
• Install the heater on the wall frame.
Fitting the stones
Upon stacking the stones, one should monitor that the heating
elements are not bent and that there is a sufficient air circulation
around the heater elements.
• The stones must be washed clean before laying.
• Stack the stones sparsely between the heating elements. When
the stones have been stacked too close to each other, the heating
elements may overheat (= shorter useful life) and slow the heating of
the sauna.
6
Output Elements
kW
4.5
6
9 1.5 / 2
Circuit Breaker
kW
1.5 3 × 10
2 3 × 10
3 × 16
Power cable
A mm
5 × 1.5
5 × 1.5
5 × 2.5
2