TROUBLESHOOTING
EN
1� No light on the button.
2� No coffee.
3� Coffee is not hot enough.
4� Unusual coffee flow.
5� Water leakage.
6� Capsule is not ejecting correctly.
7� Coffee leakage.
8� Machine turns to "OFF" mode.
9� Coffee grounds in the cup.
GREEN LIGHT
10� The machine does not start and has GREEN steady lights.
11� GREEN light blinking continuously and machine not
running.
12� GREEN light turning while machine is running.
28
ASSISTANCE VIDEOS ARE AVAILABLE ON
WWW.NESPRESSO.COM - VISIT THE "MACHINES" SECTION
➔
The machine has turned "OFF" automatically; push the button to turn the machine "ON".
➔
Check the plug, voltage, and fuse.
➔
Check that the light on the button is GREEN.
➔
Check that the water tank is filled and is well positioned.
➔
Check that a fresh capsule is inserted in correct position, that the machine head is closed and push the button to start.
➔
Descale if necessary.
➔
Open the machine head and let the capsule be ejected. Then perform a cleaning as per cleaning section.
➔
Preheat cup with hot water from the tap.
➔
Descale if necessary.
➔
Check that the water tank is well positioned.
➔
Open the machine head and let the capsule be ejected. Then perform a cleaning as per cleaning section.
➔
Descale if necessary.
➔
Check that the water tank is well positioned.
➔
Empty and clean the capsule container.
➔
If problem persists, call the Nespresso Club.
➔
Open the machine head. Remove the power cord from the grid. Clean the metallic
clamps with precaution. Be careful of the sharp edges in the machine head.
➔
If problem persists, call the Nespresso Club.
➔
Open the machine head and let the capsule be ejected. Then perform a cleaning.
➔
Empty and clean the cup support.
➔
Descale if necessary.
➔
If problem persists, call the Nespresso Club.
➔
To save energy the machine will turn off after 9 minutes of non-use.
➔
See paragraph on "Energy Saving Concept".
➔
Start the cleaning procedure. See paragraph on "Cleaning".
➔
Check the machine head is properly closed.
➔
If you want to brew a Mug, Gran Lungo or Espresso, check that a fresh capsule is inserted in correct position, that the
machine head is properly closed and push the button to start.
➔
The machine is heating up and it will take maximum one minute to be ready.
➔
This indicates the machine is working properly.