Changing The Reception Sensitivity For Automatic Scanning; Changing The Radio Band Location - Fujitsu Ten Eclipse CD4000 Manuel D'utilisation

Changing the reception
sensitivity for automatic
scanning
The equipment lets you select the reception
sensitivity to be used for automatic scanning of
stations. The two sensitivity modes available for
this equipment are LOC mode and DX mode.
During automatic scanning, the
reception sensitivity switches
automatically to one of two levels.
Initially the reception sensitivity is
set to the low level so that only
LOC Mode
stations with strong signals are
received. If no stations could be
received, the reception sensitivity is
increased so that stations with
weaker signals can also be
received.
Because the reception sensitivity for
automatic scanning is set to the high
level from the start, even stations
DX Mode
with weaker signals can be received.
(Signal crossover may result in
some stations being hard to hear.)
ATTENTION
When an optional
connected, reception sensitivity is set to the
LOC Mode. The DX Mode is unavailable.
(U.S.A. only)
Check that the equipment is in
1
standby mode.
Press and hold the button [1], then
2
the [FM AM] button, and hold both
for more than three seconds.
The mode switches between LOC
mode and DX mode each time the
buttons are pressed.
HD Radio tuner is
How to operate the tuner
Changing the radio band
location
The location for the radio bands used between
the North American region and the Asia/
Australia/Latin region can be switched. The
default setting is USA (North America).
ATTENTION
When an optional
connected, radio band location is set to USA.
Other radio band locations are unavailable.
(U.S.A. only)
Check that the equipment is in
1
standby mode.
Press and hold the button [3], then
2
the [FM AM] button, and hold both
for more than three seconds.
The radio band switches in the order
shown below each time the buttons
are pressed.
USA ➔ ASIA ➔ AUS ➔ LATIN
➔ USA
After this, the broadcast stations will
be searched for automatically and
stored in the buttons [1] to [6].
HD Radio tuner is
25
V